Evidence used
- No CISA KEV confirmation is currently recorded.
- A structured source references public exploit or proof-of-concept material.
- EPSS is 0.24% for the current model date.
BlackTreeCVE IntelligenceFull vulnerability report · 2026
CVE-2026-10642High confidence
Unbounded TX busy-loop DoS in Zephyr PL011 UART driver under CTS hardware flow control
zephyrproject · zephyr
Official source article: GitHub GHSA-3FGH-73JH-2Q5J ↗. Check the applicable product and release in the original source.
4.6MediumCVSS 3.1
Within 7 days
Patch availableMedium technical severity with public exploit material referenced by a structured source; prioritise exposed affected systems while verifying vendor guidance.
R
Open reassessment dashboard →Operational reassessment
Published severity in operational context
Published severityMedium→Operational priority:Medium, unchanged from published severity.unchanged
Compensating controls
- Validate the affected product branch and deploy the verified fixed release.
- Restrict local access and enforce least privilege on affected hosts.
- Increase monitoring for the attack path and post-exploitation behaviour described in the report.
Verification
- Confirm that the asset runs zephyrproject zephyr and falls inside the recorded affected range.
- Verify the installed build against the product-specific fixed version after deployment.
- Validate exposure, authentication requirements and compensating controls in the actual environment.
- Reopen this reassessment when CVSS, KEV, EPSS, exploit evidence or remediation changes.
Medium technical severity with public exploit material referenced by a structured source; prioritise exposed affected systems while verifying vendor guidance.
Patch available01
What, why and how
The Zephyr PL011 UART driver (drivers/serial/uart_pl011.c) contains an unbounded software loop in pl011_irq_tx_enable() that repeatedly invokes the interrupt-driven application callback while the TX interrupt mask bit (PL011_IMSC_TXIM) is set, to work around the controller's level-transition TX-interrupt behavior. When CTS hardware flow control is enabled (devicetree hw-flow-control or runtime UART_CFG_FLOW_CTRL_RTS_CTS) and the wired serial peer de-asserts CTS, the controller stops draining the TX FIFO; pl011_fifo_fill() then returns 0 on every call while the application still has pending data and therefore never disables the TX interrupt. The loop condition never clears, so the thread that called uart_irq_tx_enable() (e.g. h4_send() in the Bluetooth HCI H4 driver) spins indefinitely, hanging the executing context and stalling the transport — a denial of service (CWE-835). An attacker controlling the device attached to the UART's CTS line can trigger the hang by withholding CTS during transmission. Because that peer is the device wired to the UART — which may be a removable or external module (e.g. an off-board Bluetooth controller on the HCI H4 link) rather than a permanently-bonded on-PCB part — the attack vector is scored Adjacent (AV:A) rather than Physical; the security subcommittee should confirm the vector against the specific deployment. Impact is availability only; there is no memory-safety, confidentiality, or integrity consequence. The vulnerable loop was introduced in commit b783bc8448ef (Feb 2025) and shipped in releases v4.1.0 through v4.4.0. The fix breaks out of the loop when CTS is blocking and arms the CTS modem-status interrupt to resume transmission when CTS re-asserts.
What
The Zephyr PL011 UART driver (drivers/serial/uart_pl011.c) contains an unbounded software loop in pl011_irq_tx_enable() that repeatedly invokes the interrupt-driven application callback while the TX interrupt mask bit (PL011_IMSC_TXIM) is set, to work around the controller's level-transition TX-interrupt behavior. When CTS hardware flow control is enabled (devicetree hw-flow-control or runtime UART_CFG_FLOW_CTRL_RTS_CTS) and the wired serial peer de-asserts CTS, the controller stops draining the TX FIFO; pl011_fifo_fill() then returns 0 on every call while the application still has pending data and therefore never disables the TX interrupt. The loop condition never clears, so the thread that called uart_irq_tx_enable() (e.g. h4_send() in the Bluetooth HCI H4 driver) spins indefinitely, hanging the executing context and stalling the transport — a denial of service (CWE-835). An attacker controlling the device attached to the UART's CTS line can trigger the hang by withholding CTS during transmission. Because that peer is the device wired to the UART — which may be a removable or external module (e.g. an off-board Bluetooth controller on the HCI H4 link) rather than a permanently-bonded on-PCB part — the attack vector is scored Adjacent (AV:A) rather than Physical; the security subcommittee should confirm the vector against the specific deployment. Impact is availability only; there is no memory-safety, confidentiality, or integrity consequence. The vulnerable loop was introduced in commit b783bc8448ef (Feb 2025) and shipped in releases v4.1.0 through v4.4.0. The fix breaks out of the loop when CTS is blocking and arms the CTS modem-status interrupt to resume transmission when CTS re-asserts.
Why
A malformed condition prevents a loop from making progress or terminating, allowing resource exhaustion.
How
An attacker operating through physical access may attempt exploitation without authentication or user interaction. If successful, the issue may disrupt the affected service.
What
The Zephyr PL011 UART driver (drivers/serial/uart_pl011.c) contains an unbounded software loop in pl011_irq_tx_enable() that repeatedly invokes the interrupt-driven application callback while the TX interrupt mask bit (PL011_IMSC_TXIM) is set, to work around the controller's level-transition TX-interrupt behavior. When CTS hardware flow control is enabled (devicetree hw-flow-control or runtime UART_CFG_FLOW_CTRL_RTS_CTS) and the wired serial peer de-asserts CTS, the controller stops draining the TX FIFO; pl011_fifo_fill() then returns 0 on every call while the application still has pending data and therefore never disables the TX interrupt. The loop condition never clears, so the thread that called uart_irq_tx_enable() (e.g. h4_send() in the Bluetooth HCI H4 driver) spins indefinitely, hanging the executing context and stalling the transport — a denial of service (CWE-835). An attacker controlling the device attached to the UART's CTS line can trigger the hang by withholding CTS during transmission. Because that peer is the device wired to the UART — which may be a removable or external module (e.g. an off-board Bluetooth controller on the HCI H4 link) rather than a permanently-bonded on-PCB part — the attack vector is scored Adjacent (AV:A) rather than Physical; the security subcommittee should confirm the vector against the specific deployment. Impact is availability only; there is no memory-safety, confidentiality, or integrity consequence. The vulnerable loop was introduced in commit b783bc8448ef (Feb 2025) and shipped in releases v4.1.0 through v4.4.0. The fix breaks out of the loop when CTS is blocking and arms the CTS modem-status interrupt to resume transmission when CTS re-asserts.
Why
A malformed condition prevents a loop from making progress or terminating, allowing resource exhaustion.
How
An attacker operating through physical access may attempt exploitation without authentication or user interaction. If successful, the issue may disrupt the affected service.
02
Exploit reality and attack path
CVSS severity, EPSS forecast probability, public exploit material and CISA-confirmed exploitation are separate signals.
Observed exploitation No confirmed evidence
?
Confirmed exploitation and public exploit material are separate signals. Attacks can occur without public proof-of-concept or exploit code.No CISA KEV match was present at the last successful refresh. This means no confirmation from that source, not proof of no exploitation.
Public PoC / exploit material Reference recorded
?
Confirmed exploitation and public exploit material are separate signals. Attacks can occur without public proof-of-concept or exploit code.A structured CVE source labels at least one public reference as exploit material. BlackTree has not independently validated that it is safe, reliable or weaponised.
- Likely attack path
- physical access → Loop with Unreachable Exit Condition ('Infinite Loop') → disrupt the affected service
- Attack surface
- Physical
- Privileges required
- None: unauthenticated exploitation is possible
- User interaction
- None
- Attack complexity
- Low: no specialised conditions are recorded
- Security boundary
- Unchanged: impact remains within the vulnerable component's security authority
- Weakness
?
CWE means Common Weakness Enumeration: a standard category for the underlying weakness. - CWE-835 ↗
CWE-835: Loop with Unreachable Exit Condition ('Infinite Loop'). The product contains an iteration or loop with an exit condition that cannot be reached, i.e., an infinite loop.
- CVSS vector
?
CVSS means Common Vulnerability Scoring System. The vector records the metric values used to calculate technical severity. CVSS:3.1/AV:P/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:HCommon Vulnerability Scoring System 3.1: the compact vector below is decoded into plain language.
AVPhysicalAttack vector: The attacker needs physical access to the vulnerable system.ACLowAttack complexity: No specialised conditions are required beyond attacker-controlled input.PRNonePrivileges required: The attacker does not need an account or existing privileges.UINoneUser interaction: No action by another user is required.SUnchangedScope: The security impact remains within the vulnerable component's authority.CNoneConfidentiality impact: No direct loss is represented by this metric.INoneIntegrity impact: No direct loss is represented by this metric.AHighAvailability impact: A successful attack can cause a major loss.- Post-exploitation / living off the land
- No specific living-off-the-land technique is confirmed in the structured sources. Monitor normal administration tools for activity inconsistent with the affected service's baseline.
03
Patch and workaround
Operational remediation based on structured source evidence.
- Status
?
Patch availability is based on structured fixed-version fields and authoritative update references. If no fix is verified, check the vendor advisory before making a change. - Patch available
- Affected
- zephyr: 4.1.0 < 4.5.0
- Action
- Review the linked authoritative reference and apply the recorded fixed release appropriate to the affected product branch.
- Workaround
- No verified workaround is recorded. Limit untrusted access and use least privilege until authoritative guidance is available.
04
Evidence and provenance
Published 24 Jun 2026 · Last source change 14 Jul 2026, 18:38 UTC · CWE-835 · Loop with Unreachable Exit Condition ('Infinite Loop')
CVE recordCVE.org · 5.2
CVSS sourceCNA
EPSS source FIRST · tracked since 2026-08-14
?
The date BlackTree first stored a score for this CVE from the daily FIRST EPSS feed.European sourceENISA EUVD · EUVD-2026-39106
Product sourceCNA
Remediation sourceCVE/CNA references
CWE sourceCNA
NVD statusNVD modified after enrichment
Core structured fields are present and their contributing authorities are shown above.
Material change intelligence
View recent updates ↗What changed after publication
No material field changes have been recorded since change tracking began. Routine source refreshes and cosmetic edits are intentionally excluded.
CVE published
Fixed release or patch reference recorded
Technical terms and abbreviations used in this report
- CVE
- Common Vulnerabilities and Exposures: the public identifier for one disclosed vulnerability.
- CVSS
- Common Vulnerability Scoring System: a technical severity framework; it is not patching priority by itself.
- EPSS
- Exploit Prediction Scoring System: FIRST's estimate of the probability that exploitation activity will be observed in the next 30 days; it is a forecast, not confirmation.
- CWE
- Common Weakness Enumeration: the standard category describing the underlying software or hardware weakness.
- CNA
- CVE Numbering Authority: an organisation authorised to assign and publish CVE records.
- CISA ADP
- Cybersecurity and Infrastructure Security Agency Authorized Data Publisher: structured enrichment added to a CVE record.
- NVD
- National Vulnerability Database: NIST's enrichment service for CVE records.
- CERT / CSIRT
- A computer security incident response team that publishes warnings or coordinates incident response.
- PoC
- Proof of concept: public material that demonstrates or helps reproduce exploitation.
- CSAF
- Common Security Advisory Framework: a machine-readable format for security advisories.
- LoTL
- Living off the land: abuse of legitimate tools or system functions during an attack.